Based on the same design features of the LF-690 Hydraulic Regulator, the LF-692 incorporates a PEEK seat for use on high pressure gases, using a range of precision machined sensing elements to provide control of pressure to 690 bar. The regulator is self relieving with segregated captured vent to allow vented gases to be piped away to a safe area. The seating area can easily be accessed from the base of the regulator for speedy servicing in situ.
A compact and economical high pressure regulator with precision machined sensing elements to allow fine pressure control on pressures up to 414 bar, which can be supplied as none venting or self venting (none adjustable). FEATURES 550 bar / 8000 psi inlet pressure Economical Design Precision machined sensing elements Load bearings and large handwheel for low torque adjustment Excellent sensitivity Self venting and non venting options
The MF-101 incorporates a large precision machined sensing element to control outlet pressures up to 35 bar from a maximum 100 bar inlet. The main valve is an unbalanced design to create positive shut off on gas or liquid applications against the PEEK seat. Lightweight compact design Piston sensing element High accuracy
The LF-301 provides a compact and economical solution for controlling pressures up to 180 bar on low flow applications.Ideal for first stage pressure let down where basic pressure control is required. A small piston sensing element allows low torque adjustment with a range of springs with fine pressure adjustment. FEATURES Compact design Economical 316SS Bonnet Max 300 bar inlet
The LF-300 has been designed with quality and reliability in mind, with genuinely unique features designed into this single stage regulator. Finite Element Analysis, combined with physical cycle tests, created an Inconel X750 diaphragm that lasts 50 % longer than a typical stainless steel designs.The metal diaphragm means that leak integrity is maintained, and that no sample media is absorbed by the sensing element – reducing purge times be
The BP-LF690 is a back pressure regulator for gas or liquid applications suited for typical low flow applications to 10lpm (liquid), this accurate regulator controls inlet pressure and vents excess pressure back via the threaded ¼” NPT outlet port. FEATURES 690 bar/10000 psi inlet pressure Metal to metal seating for liquid and PEEK seating for Gas Precision machined sensing elements 3 Sensor ranges for combination of low torqu
An economical heated regulator available in ‘side entry’ or ‘in-line’ heat transfer options to maintain sample gases in their vapour state. The ‘in-line’ design maximizes the heat transfer area via a unique spiral machined heater sheath, which mixes the gas and ensures efficient heat transfer. The ‘side entry’ design can be used in applications where heat transfer is less critical, and where install
FEATURES 316L SS Machined Wetted Parts Large sensitive elastomeric diaphragm 0,1 bar to 10 bar / 1,5 psi to 150 psi control range Minimal decaying inlet pressure effect For flow rates to 30Nm³/hr (@ max P2)
The BP-301 incorporates a highly sensitive piston to control pressures up to 70 bar with the lower Cv value of 0.1, and 35 bar with a higher Cv of 0.5. Both designs provide accurate back pressure control on liquid or gas applications. Unlike relief valves, the set load from the spring is not directly applied to the seating area, and the piston sensor provides accurate control throughout the control range. FEATURES Lightweight compact design
The TS-300 provides stable pressure control under decaying cylinder pressures. The first stage of the regulator is set to 35 bar to allow maximum flow capability through the regulator. SPECIAL FEATURES Metal to metal sealing diaphragm Sealing area protected and centralized within the body of the regulator 0,04 % decaying pressure effect ‘Interstage’ relief valve option